Frequently
Asked Questions
Q- What if a wire on the unit is broken, will it still
operate and shut down the engine?
A- If any of the 3 wires on the unit is broken, you will not be
able to run the engine. You will be able to turn the engine over
with the starter, but it will not run.
Q- I have an engine on my son's go cart that I want to
shut off, will your units work.
A-If your son's go-cart has a 12 volt battery that the engine charges,
you can use either the Model 200 or the Model 100.
Q- Explain the difference between the Model 100 and the
200.
A-When you want to remotely shut off the engine the model 100 and
200 operate the same. You press the transmitter button and the unit
shuts off the engine. The model 100 is designed differently, in
that you have to press the transmitter button to start the engine.
Model 100-You want to start the engine, you turn on the key to start
the engine, you can crank and crank on the engine, but the ignition
circuit is disabled. It will not start. You need to press the transmitter
button, which turns on the ignition circuit, and then the engine
will start. You want to shut off the engine, press the transmitter
button again, the engine stops. Model 200- You can start up the
engine with out the transmitter. Just like normal, turn on the key,
start the engine, turn off the key, the engine stops, but you now
have remote shut down. The Model 100 just has the extra safety feature
built in, where the transmitter has to be present to even start
the engine. If you have the Model 100 installed on your piece of
equipment, and you accidently take the transmitter home with you
at the end of the day, and return to work the next morning and forget
your transmitter, you will not be able to start the engine on the
piece of equipment.
Q- I have an electric start small engine, with a charging
system, but it has no key start. You push a button to start, and
you push a little lever that grounds to the frame and the engine
stops. Will any of your models work on my engine?
A- All models work.
Q- I have rock crusher. I want the operator that feeds
the jaw, be able to shut off the jaw motor incase of an over size
rock or some foreign object is about to enter the jaw. Will the
Model 400 work in this application?
A- The Model 400 was designed for shutting down of electric motors
or devices. Individual motors or multiple motors.
Page 1>> Page
3
|
