Fox-Paws Model 375

Fox-Paws Model 375

$1,069.95

Applications: Simply shut off for gas or diesel engines controlled by computer/engine module.
The Model 375 can only be plugged into the fuse circuit in the fuse panel that controls the engine.
The Model 375 has been designed to be versatile and user-friendly. Besides it's plug-n-go capabilities, it can be configured at the factory with the Model 100,200,225 circuitry. It&#039&#039&#039's receiver can be programmed up to 16 transmitters, making this unit capable of handling larger transmitter based applications. The unit has a removable magnetic base, manual override feature, harness that plugs into fuse panel and cigarette plug that attaches to a 12-volt receptacle.
Ask our sales team how the Model 375 can be configured to meet your safety needs.

Features:

 

Non-detachable 7-10 foot wire harness.

1-transmitter included in price (optional water resistant enclosure available)

Mounting bracket with a magnet.

Expandable up to 16 transmitters

 

Dimensions:

9.5in. x 4.75 in. x 2.5in.

12 volt D.C.   Optional 24 to 12 volt converter available

900 MHZ Frequency

Range 1/4 mile line of sight

Easy plug-n -go system installation.

Green/Run, Red/Stop, Yellow/Low Battery indicator.

Weather resistant enclosure (N.E.M.A. 4  )
See Details below, see how easily the Fox-paws 375 can be installed.

Product Description

 

Installation:

Step #1 -Find the fuse in the panel that controls the engine. Pull out this fuse, plug our wire harness into this fuse slot and put the fuse that you pulled out of the panel, back  into our wire harness. The computer now is controlled by Fox-Paws with the same protection of the original fuse.

Engine control fuse

Step #1 -Find the fuse in the panel that controls the engine.

plug in harness

plug our wire harness into this fuse slot

inserting inline fuse

put the fuse that you pulled out of the panel, back into our wire harness

 

 

 

Step# 2  Locate a 4-inch diameter flat spot and stick the mounting bracket magnet to this spot.  If the unit is going to be permanently mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.

mounted fox-paws unit

Step# 2 Locate a 4 inch diameter flat spot and stick the mounting bracket magnet to this spot.

 

Step #3 Find a clean ground point and attach the Green ground clamp.

 

Green ground Clamp

Step #3 Find a clean ground point and attach the Green ground clamp

If the unit is going to be permanently mounted to the vehicle or equipment, the magnet can be removed and bolted with the 2 holes in the bracket.

perminent ground

If permanently mounted the ground clamp can be removed at the harness connection and the eyelet ring can be attached to the wire harness and the eyelet ring can be bolted to a ground point.

.

 

When the installation is complete test unit as described below:

Turn on the ignition key, make sure GREEN LED lights on top of Fox-Paws enclosure; if it does not light, make sure the ground is good, if the GREEN  still does not light,  turn the key to off position, pull wire harness out of fuse panel and turn over and plug back in.  Turn key to on position.  Fox-Paws  GREEN LED should turn on.

To operate unit: Turn on key, start vehicle/equipment. To shut down engine; turn off key or press transmitter. If the transmitter is used: turn off key, wait 5 seconds, turn the key back on to restart the engine.

If the Model 225 board is used; after transmission, press reset button on top of the enclosure.

 

Reviews

There are no reviews yet.

Be the first to review “Fox-Paws Model 375”